|
Switch mounting block for
the DPDT push-push button switch.
This
DPDT push-push button switch mounting block is same style as
installed in the Fender Deluxe Player, Jeff
Beck, American Elite Strat® and
various other models that use this push button
switching method, but this specific switch
mounting block is shorter for it uses a slightly
different switch cap/tips. It is
NOT the same as
our original #SMB, this switch mounting
block is shorter to accommodate the different
switch cap, since Fender no longer sells the
original switch caps we are now using the
original switch caps that are made by the switch
manufacturer and requires a slightly larger hole
in the pickguard, only about 0.01" larger. This
switch mounting block is exclusively
used/included in our
225800-KIT-REV2 kits.
This switch mounting block is attached to the
back side of the pickguard with a strong glue
such as Devcon 22045. In the location where you
are gluing the switch mounting block you will
remove a small portion of the pickguard
shielding, score the pickguard surface and scuff
the mating surface of the switch mounting block
for best adhesion. A
9mm" diameter hole in your pickguard is
required for this switch mounting block to
allow the switch tip to protrude through. A
step
bit is a good choice for drilling the hole in
the pickguard and the 9mm is one of the
diameters on the 4 - 12mm step bit.
Length: 0.710".
Width: 0.483".
Height: 0.357".
Hole Diameter: 0.355".
Plain Packaged.
|
Click on above image
for larger view |
 "DPDT Push-Push Switch Mounting Block")
