An OverDrive Custom Guitar Works
for 2017 is our fat Strat®
HSS black 1 ply 0.120" acrylic pickguard with our signature
feature of the rounded and polished perimeter edge.
Your everyday typical Strat® pickguard
will have a
45° beveled edge that is found on just about any Strat® for the
last 50+ years. The rounding and polishing of the
perimeter edge of a pickguard gives it a
presence and style that really sets it apart
from the rest, see photograph below.
These pickguards are
the same style found on Gilmour's Black
Strat® except these do not
have the small slot for the recessed mini-toggle switch
and these are for a Humbucker and two single coil
This pickguards bridge
pickup cut-out dimensions are designed around
Seymour Duncan's Trembucker design (without a metal
cover) which is proper for a tremolo bridge equipped
Strat. The bridge pickup mounting uses a
standard 2 screw system with a mounting spacing of 3.10".
This pickguards middle and
neck pickup cut-outs are dimensioned for standard single
Be sure to confirm your pickups
for compatibility with this pickguards
specifications before ordering.
This pickguard has a standard 11 hole
mounting pattern, the selector switch and single
coil pickup mounting holes are not countersunk
and require Phillips round head
mounting screws. Potentiometer mounting holes
are standard 3/8" in diameter. Each pickguard is copper foil
shielded in the control region only.
- Neck Pickup: Standard. Single Coil
- Middle Pickup:
Standard Single Coil
- Bridge Pickup
Cut-Out: 2.853" x 1.48"
- Bridge Pickup Mounting:
Each pickguard is
manufactured on an "As
Ordered" basis. There is up to 14 day build time on
these pickguards. No returns or exchanges
so be sure of your pickups compatibility and
mounting requirements before
Until April 2017